Let’s say there’s a table with 10 lines.
Let’s set an autofilter where you can see only lines 2, 4, and 6.
Then, if you select lines 4 and 6 the status bar shows this:
Selected: 3 rows
That is wrong. There are only 2 rows selected. I guess the application counts from 4 to 6 which would be 3 rows.
Then if you apply a different background color to the selected rows and then deactivate the filter, only those 2 rows will have the new color, which is right. So there were only 2 rows selected.
I asked a similar question last week and saw that my question was finally a bug. I reported and receive confirmation that it was a bug but it was already reported a long time ago.
I guess this is another bug but I haven’t found any information about it.
I’m using LibreOffice 188.8.131.52